Ramsey Winch 800/H-800 DOW-LOK - Manual (Page 14)

12
(8)
Check for signs of wear on gear teeth. If necessary, replace
gear.
Check lube fittings (item #78) for damage and replace if nec-
essary. Remove lube fittings (item #78) and reducers (item
#62) from ends of shaft, if following Step 9, and reinstall
after Step 9.
(9)
If shaft and/or gear hub is damaged, replace as follows:
a. Tap keys (item #25) into short keyways of drum shaft
(item #27).
b. Press shaft (item #27) and keys through gear hub (item
#17) until end of keys on long end of shaft are flush with
hub.
(10)
Check gear housing bushing (item #5) and o-ring (item #63) for signs of
wear. Replace if necessary by pressing old bushing from gear housing (item
#20). Press new bushing into place and insert new o-ring (item #61) into
groove inside of bushing.
(11)
Check drum bushings (items #35 & #36) for signs of
wear. Replace if necessary by pressing old bushings from
drum (item #14). Press bushing (item #35) into bore in
drum until it's flange is seated against bottom of counter-
bore. Press bushing (item #36) into opposite bore on
drum until end of bushing extends .50" from end of drum.
62
62
78
78
27
54 17
45
22
25
27
25
17
20 61
5
36
35
14