Ramsey Winch REP 8000 & 9000 - Manual (Page 8)

Repositioning Shifter for Specific Bull Bar Applications
Note: The shifter is positioned correctly for most applications. It will only need to be repositioned as necessary for specific bull
bar applications.
Refer to the Parts List and Exploded Parts Diagram for your specific winch elsewhere in this owner’s manual.
1. Position winch as shown in Figure 7. Remove screws from tiebars. You may be able to loosen the screws at the motor end
without removing them. Pull the Gear Housing assembly from the drum and shaft and set it down on the work bench with
the Gear Housing Cover up. Remove the drum bushing from the Gear Housing assembly or the end of the drum. Set aside.
2. Remove (6) capscrews from
the Gear Housing Cover.
Holding the Gear Housing
Cover over the Gear Housing
assembly, flip it over and set it
on the workbench.
3. Gently lift the Gear Housing assembly,
working the gears, bushings, etc. that
are inside the Gear Housing out so that
they are left stacked on the workbench.
See Figure 9.
4. Turn the Gear Housing assembly over
and set on workbench. Remove the
Retainer (item #37) by removing six
capscrews (item #21) from Gear End
Bearing (item 13). Once the retainer is
removed, the Ring Gear (item #10),
Cam Ring (item #36), and Locking Ring
(item #34) can be lifted off the end
bearing.
Remove the six springs (item #38) from
the end bearing.
6
3
28
1
23
2
40
10
40
17
41
16
12
29
11
39
21
13
38
36
34
10
37
FIGURE 7
FIGURE 9
FIGURE 8