Lincoln Electric 718113 Spirit II 150 - Manual (Page 156)

Appendix B: Serial Communication Spirit II User’s Manual
This information is subject to the controls of the Export Administration Regulations [EAR]. This information shall not be provided to
non-U.S. persons or transferred by any means to any location outside the United States contrary to the requirements of the EAR.
B-8
Command # Hex String Additional Information
Restore Factory
Condition
47 AA nn FA 2F 00 01 0D Restores the factory cutting condition for the
present material type and thickness.
Cutting Condition
Type
48 AA nn FA 30 00 -- 0D If requested in command #30, the system will
transmit whether the present cutting condition is a
factory default setting or a custom user setting.
Note: This is only valid when initially loading
material type, thickness, and process.
0 = factory / 1 = custom
Configure H17
Cutting
49 AA nn FA 31 00 -- 0D 0 = Disable H17 cutting
1 = Enable H17 cutting
Reload Cutting
Condition
50 AA nn FA 32 00 01 0D Reloads the cutting conditions for the present
material type and thickness
Set Arc Off Delay
Time
51 AA nn FA 33 -- -- 0D Sets the delay time in mS between the reception
of a stop signal and the extinction of the arc.
Valid Range: 0 to 2000 mS
Machine Type 52 AA nn FA 34 -- -- 0D If requested in command #30, the system will
transmit the machine type.
153 = Spirit150a
203 = Spirit200a
273 = Spirit275a
403 = Spirit400a
Set Marking Arc
Voltage
53 AA nn FA 35 -- -- 0D Sets marking arc voltage in Volts x 100
Valid Range: 5000 to 20000
Set Marking Height 54 AA nn FA 36 -- -- 0D Sets marking height in mils (inches / 1000)
Valid Range: 0 to 999
Set Marking Start
Height
55 AA nn FA 37 -- -- 0D Sets marking start height in mils (inches / 1000)
Valid Range: 0 to 999
Set Marking Travel
Speed
56 AA nn FA 38 -- -- 0D Sets marking travel speed (inches / min)
Valid Range: 0 to 999
Set Marking Pierce
Time
57 AA nn FA 39 -- -- 0D Sets marking pierce time in ms
Valid Range: 0 to 9999
Configure
Cut/Mark/Cut
59 AA nn FA 3B 00 -- 0D 0 = Local at power supply
1 = Hard signal via interface plug
2 = RS-422
Node Focus 254 AA C8 FA FE 00 nn 0D Sends a global command to all systems and sets
the node focus to system nn