Lincoln Electric IM10023 MAXsa 10 CONTROLLER - Manual (Page 32)

B-17 OPERATION B-17
SAVING A PROCEDURE TO A MEMORy
LOCATION
Once the parameters have been set:
• Press and Hold the Memory Button of the
desired location for 2 seconds.
• The LED for that location will come ON.
• After 2 seconds the LED will go OFF
• The MSP display will show briefly that the informa-
tion is saved, then return to the Weld Mode.
NOTE: Holding the button for longer than 5 sec-
onds will enter the Limits Mode.
RECALLING A PROCEDURE FROM A
MEMORy LOCATION
• Press and release the desired Memory Button.
• The LED for that location will come ON and the
stored procedure information will show in the dis-
plays.
• The LED will remain ON until another location is
selected
NOTE: Holding the button for longer than 1 sec-
ond will re-enter the “Save” Mode.
MAXsa™ 10 CONTROLLER
FIGURE B.8 - MEMORy
200
Steel 1/8”
CC DC
30
.
5
58
+
MEMORY
BUTTON
LED
INDICATOR
MSP
DISPLAY
Hold for 2 Seconds
to Save
Press and Release
to Recall
Memory 1
Saved