Lincoln Electric IM10085 ACTIV8 - Manual (Page 19)

A-10 INSTALLATION
ACTIV8™
A-10
PROCEDURE TO INSTALL CONDUIT BUSHING FOR THE WIRE FEEDER UNIT
M22832
3. Insert flex tube into new conduit bushing. Insert the thumb screw into the new conduit bushing and
tighten the thumb screw. The thumb screw threads will lock the flex tube into place (See Fig. 2).
4. Install the new conduit bushing, flex tube and thumb screw into the wire feed head.
5. Tighten the set screw.
PROCEDURE TO INSTALL CONDUIT BUSHING
When inching with gun trigger, electrode and drive mechanism
Only qualified persons should install, use or service this machine.
are "hot" to work and ground.
Turn off the Welding Power Source before installing or changing
drive rolls and / or guides.
SHOCK
ELECTRIC
WARNING
CAN KILL
A.01
1. Turn OFF Welding Power Source.
2. Loosen the set screw which secures the existing incoming guide bushing and remove the
incoming guide bushing from the wire feed head (See Fig 1).
WIRE FEED HEAD
SET SCREW
INCOMING GUIDE BUSHING
FIG 1
CONDUIT BUSHING
(PART OF K1546-2, INCOMING BUSHING KIT)
FLEX TUBE (T10642-325)
WIRE FEED HEAD
SET SCREW
THUMB SCREW
(PART OF K1546-2, INCOMING BUSHING KIT)
FIG 2