IEI Integration EC-1040G - Manual (Page 49)

EC-1040GB Workstation
Page 39
Step 2: If necessary, remove the CPU card clamp. (See Section 4.5.2)
Step 3: Slide the PCI/ISA expansion card into the reserved PCI/ISA socket on the
backplane.
Step 4: To secure the PCI/ISA expansion card, reinsert the previously removed slot
cover retention screw and reinstall the hold down bar. Step 0:
4.5.11 Connect the Cables
The following cables may have to be connected depending on the CPU board and the
backplane installed in the system:
ƒ PSU cables must be connected to the following components (if installed):
o CPU card
o Backplane
o FDD
o HDD
o Optical drive
ƒ Disk drive ribbon cables must be connected to the corresponding CPU card
disk drive connectors.
Other connections may have to be made; please refer to the documentation that came
with the CPU card.
4.5.12 Close the Top Cover
Before closing the top cover, make sure the following items have been completed:
ƒ The backplane is properly installed
ƒ The CPU card is properly installed
ƒ The PCI/ISA expansion cards are properly installed
ƒ The disk drives are properly installed into the drive brackets
ƒ The drive brackets are properly reinstalled into the workstation
ƒ All cables are properly connected
If all of the above listed items have been properly installed, close the top cover and
reinsert the previously removed retention screws.