IEI Integration RPC-6022G - Manual (Page 65)

RPC-6022GW Rackmount LCD Workstation
Page 65
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Step 8:
Step 9:
Step 10:
Step 11:
Step 12:
Step 13:
Step 14:
5.2 CPU Card Replacement
To replace a CPU card, please follow the instructions below.
Turn off and disconnect the workstation from all power sources.
Remove the workstation from the rack in which it is installed.
Open the top cover of the RPC-6022GW Rackmount LCD Workstation. (See
Section 4.5.1)
Disconnect all internal and external peripheral device connections from the CPU
card.
Remove the CPU card clamp. (See Section 4.5.2)
Remove the retention screw that secures the CPU card to the slot on the rear
panel.
Remove the card bracket from the fan bracket by removing two retention
screws.
Slide the CPU card out of the workstation.
Install a new CPU card. (See Section 4.5.8)
Insert the slot retention screw that was removed earlier.
Reinstall the CPU card clamp.
Reinstall the card bracket and secure it with two screws removed earlier. Make
sure the back edge of the CPU card slides into the guide rails of the card
bracket.
Reinstall the top cover of the workstation. (See Section 4.5.12)
Reinstall the workstation into the rack. Refer to Section 4.6 for complete
mounting instructions. Step 0: