Figure 4-2: so-dimm socket location – IEI Integration AFL-19i-HM55 v1.01 User Manual
Page 67

AFL-HM55 Series Panel PC
Page 55
Figure 4-2: SO-DIMM Socket Location
Remove the DDR memory module by pulling both the spring retainer clips outward from
the socket.
Grasp the DDR memory module by the edges and carefully pull it out of the socket.
Install the new DDR memory module by pushing it into the socket at an angle (Figure
).
Gently pull the spring retainer clips of the SO-DIMM socket out and push the rear of the
DDR memory module down (Figure 4-3).
Release the spring retainer clips on the SO-DIMM socket. They clip into place and secure
the DDR memory module in the socket.
This manual is related to the following products: