IEI Integration AFL-19i-HM55 v1.01 - Manual (Page 25)

AFL-HM55 Series Panel PC
Page 13
2.1 Unpacking
To unpack the flat panel PC, follow the steps below:
WARNING!
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the flat panel PC has been
properly installed. This ensures the screen is protected during the
installation process.
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the external
(second) box.
Open the external (second) box.
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the internal
(first) box.
Lift the monitor out of the boxes.
Remove both polystyrene ends, one from each side.
Pull the plastic cover off the flat panel PC.
Make sure all the components listed in the packing list are present.
2.1.1 Packing List
The AFL-HM55 Series flat panel PC is shipped with the following components:
NOTE:
If any of these items are missing or damaged, contact the distributor or
sales representative immediately.