IEI Integration PM-945GSE - Manual (Page 91)

PM-945GSE-N270 User Manual
Page 91
BIOS SETUP UTILITY
Main Advanced PCIPNP Boot Security Chipset Exit
Configure Remote Access type and parameters

Remote Access
[Disabled]
Serial port number
[COM1]
Base Address, IRQ [3F8H, 3]
Serial Port Mode [115200 8,n,1]
Redirection After BIOS POST [Always]
Terminal Type [ANSI]
 Select
Screen
  Select
Item
Enter Go to SubScreen
F1 General
Help
F10 Save and Exit
ESC Exit
v02.61 ©Copyright 1985-2006, American Megatrends, Inc.
BIOS Menu 9: Remote Access Configuration
 Remote Access [Disabled]
Use the Remote Access option to enable or disable access to the remote functionalities
of the system.

Disabled D EFAULT Remote access is disabled.

Enabled Remote access configuration options shown below
appear:
Serial Port Number
Serial Port Mode
Flow Control
Redirection after BIOS POST
Terminal Type
VT-UTF8 Combo Key Support
These configuration options are discussed below.
 Serial Port r [1]
Use the Detected Serial Port option to select the serial port used for remote access.