IEI Integration PM-945GSE - Manual (Page 56)

PM-945GSE-N270 User Manual
Page 56
WARNING:
A CPU should never be turned on without its heat sink being installed.
If the heat sink is removed and the system turned on, permanent
damage to the CPU, PM-945GSE-N270 and other electronic
components attached to the system may be incurred. Running a CPU
without a heat sink may also result in injury to the user.
4.3 Unpacking
When the PM-945GSE-N270 is unpacked, please do the following:
 Follow the anti-static precautions outlined in Section 4.1.
 Make sure the packing box is facing upwards so the PM-945GSE-N270 does
not fall out of the box.
 Make sure all the components in the checklist shown in Chapter 2.3.1 are
present.
NOTE:
If some of the components listed in the checklist in Chapter 2.3.1 are
missing, please do not proceed with the installation. Contact the IEI
reseller or vendor you purchased the PM-945GSE-N270 from or
contact an IEI sales representative directly. To contact an IEI sales
representative, please send an email to [email protected].
4.4 CompactFlash® Card Installation
A CompactFlash® Type II (CF Type II) card slot is located on the solder side of the CPU
board. When appropriately formatted, a CF Type II card can serve as a bootable hard
drive in applications where installation space is limited. The CF Type II card occupies a
secondary IDE channel. Configuration options can be found through the BIOS
configuration utility.
To install a CF Type II card, follow the instructions below.