IEI Integration PM-945GSE - Manual (Page 70)

PM-945GSE-N270 User Manual
Page 70
WARNING:
If the USB pins are not properly aligned, the USB device can burn out.
Step 2: Align the connectors. The cable has two connectors. Correctly align pin 1on
each cable connector with pin 1 on the PM-945GSE-N270 USB connector.
Step 3: Insert the cable connectors. Once the cable connectors are properly aligned
with the USB connectors on the PM-945GSE-N270, connect the cable
connectors to the on-board connectors. See Figure 4-14.
Figure 4-14: Dual USB Cable Connection
Step 4: Attach the USB connectors to the chassis. The USB 2.0 connectors each of
two retention screw holes. To secure the connectors to the chassis please refer
to the installation instructions that came with the chassis. Step 0:
4.8 Software Installation
All the drivers for the PM-945GSE-N270 are on the CD that came with the system. To
install the drivers, please follow the steps below.
Step 1: Insert the CD into a CD drive connected to the system.