IEI Integration ICE-945GSE v1.01 - Manual (Page 51)

ICE-945GSE COM Express Type 2 Module
Page 39
5.4 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three
metal pins and a small metal clip (often
protected by a plastic cover) that slides over
the pins to connect them. To CLOSE/SHORT
a jumper means connecting the pins of the
jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a
jumper.
Jumper Locations
Before the ICE-945GSE is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumpers on the ICE-945GSE are listed in
5
Table 5-1
and shown in Figure 5–2.
Description Type Label
LVDS panel resolution 4-in-1 switch SW1
BIOS selection 4-in-1 switch SW2
Table 5-1: Jumpers