Extron Electronics SW DVI Plus Series User Guide - Manual (Page 20)

SW DVI Plus Series • Operation 14 14
Other ways to select an input include using SIS commands (see the Input Selection
commands in the Command and Response Table for SIS Commands, “Remote
Configuration and Control” section) or the optional IR remote control (see “ Using
the Optional IR 102 Remote Control ”). Front panel input selection is disabled when
auto-input switching is in effect.
Using the Optional IR 102 Remote Control
The optional hand-held IR 102 Remote Control (part number 70-224-10) lets you remotely
perform functions that are also available through the front panel buttons and SIS
commands.
The IR receiver sensor on the front panel is located to the right of the Auto Switch Active
LED. It receives signals from the remote control if they are sent from within a 40-degree
arc to the right or left of direct line of sight between the remote control and the switcher
receiver, and from no more than 30 feet (9.1 m) away (see the illustration below).
AUTO
SWITCH
ACTIVE
SW4 DVI Plus SERIES
1 2 3 4 INPUT
EQ SIGNAL
PRESENCE IR
1
1
HIGH
LOW
2 3 4
2 3 4
SW DVI Plus Series Switcher
40 40
30’ (9.1 m)
Maximum
IR 102 Remote Control
Channel
IR 102
0
1 2 3 4
5 6 7 8
9 +10
Universal Remote
Figure 18. Area for Remote Signal Reception
Remote control buttons
On the IR 102 remote control, buttons 1 through 2, 4, 6, or
8 (depending on your model) select inputs. Button 0 mutes
(deselects) all inputs.
a
Input Selection buttons (1 through 8) — Press one of
these buttons to select an input.
b
Input Mute button (0) — Press this button to deselect
all inputs, effectively muting the output.
Locking IR remote access
The SW DVI Plus can be set to lock out users from using the IR 102 Remote Control to
control the switcher. Remote access can be enabled and disabled via SIS commands (see
“
Disable IR Receiver from Front Panel ” in the Command and Response Table for SIS
Commands,“ Remote Configuration and Control” section). When remote access is set to
Off, all switcher controls remain available through the SW DVI Plus front panel.
Universal Remote
INPUT/OUTPUT SELECTION
1 2 3 4
5 6 7 8
9 0 +10
IR 102
1
2