beautypg.com

Installing the vtg 300 batteries, Conserving the vtg 300 battery life – Extron Electronics VTG 300_300R User Guide Rev. E User Manual

Page 26

background image

Output type

Rate

16:9 HR
(cont.)

............ WSXGA

*

55.94 kHz, 1440x900 @ 60Hz

............ WSXGA+1

*

64.67 kHZ, 1680X1050 @ 60Hz

............ WSXGA+2

*

65.29 kHZ, 1680X1050 @ 60Hz

............ 1080P PC

67.20 kHz, 1920x1080 @ 60Hz

............ WUXGA1

*

74.04 kHz, 1920x1200 @ 60 Hz

.............

WUXGA2

74.60 kHz, 1920x1200 @ 60 Hz

NOTE:

For NTSC/PAL rates, the component video output is intended for signal

verification and alignment, and should not be used as a reference.

*

Firmware 2.05 or higher includes these resolutions. Units with firmware 1.xx
are not able to be upgraded to 2.xx firmware.

Installing the VTG 300 Batteries

Four AA batteries (rechargeable or alkaline) may power the VTG 300 and are easily installed.
With the protective boot removed, use a flat blade screwdriver to loosen the captive screw
and remove the rear battery pack cover. Replace the batteries while observing the correct
polarity molded in the battery cradle as the batteries are installed. Reinstall the cover (see

figure 15

).

VTG 300 Battery Install.eps

Figure 15.

Battery Installation

VTG 300/300R • Operation

20