Extron Electronics VTG 300_300R User Guide Rev. E - Manual (Page 18)

Enable at power up submenu (Enable@PwrUp)
This submenu only displays when the VTG is powered by batteries. When enabled, this
feature allows the VTG to set the active audio and/or video output during power up. This is a
power saving feature of the VTG. Press any  or  button to enable the selected outputs:
• Last used (default) – only the last used functions (audio or video) output is enabled
during power up.
• Video only (Vid) – the video outputs are enabled and the audio outputs are disabled.
• Audio only (Aud) – the audio outputs are enabled and the video outputs are disabled.
• Audio and video (Aud+Vid) – both audio and video outputs are enabled, regardless of
which outputs were last used.
NOTES: • If an output is disabled at power up, it can be reactivated by pressing one of
its function buttons.
• When the VTG is powered by the external power supply, both audio and
video outputs are enabled regardless of the setting.
Backlight submenu (BackLight)
This submenu only displays when the VTG is powered by batteries. When set to off (default),
this feature does not illuminate the backlight of the LCD. This is a power saving feature of
the VTG to extend battery life. Press any  or  button to turn the backlight on. When set
on, the backlight goes inactive (the backlight goes off, but the backlight status is still set on)
after 2 seconds of button inactivity, but will light again when any button is pressed.
NOTE: When the VTG is powered by both the external power supply and batteries, the
external power supply provides the power, not the batteries.
Unit Reset submenu (Press & Hold)
The VTG can be reset to factory default values. Any of the adjacent  or  button pairs
(Level, Frequency, or Rate) will activate the reset.
Press and hold both  or  buttons simultaneously for two seconds to reset the VTG to its
factory defaults.
• The message “ Unit Reset to Factory Defs “ will be displayed.
VTG 300/300R • Operation 12