Extron Electronics VTR001 User Guide - Manual (Page 21)

For mounting the VTT001 MAAP or VTR001 MAAP to a rack mount shelf, mount the
transmitter/receiver modules to the AV connector frame, then attach the frame to the
shelf, as shown below.
(4) #4 - 40
Screws
(4) #6 Screws
RSB 129 (60-190-01)
Rack Mount Shelf
VIDE O INPU T
VT T0 01 CM
Tw ist ed Pa ir T ran sm itte r PO WE R
CPM133 (60-584-15) or
AV Connector Frame
Figure 12. CPM133 AV Connector Frame Mounted to a Rack Shelf
For mounting the VTR001 AAP to a rack, mount the AAP modules to the Extron AAP
frame, then attach the frame to the rack, as shown below.
#4-40 Nut with
Captive Washer
AAP 301
VTR001 AAP
Twisted Pair Transmitter
AAP 301
Architectural Frame
#10-32 Screw/
Nylon Captive
Cap Washer
INPUT
VTT001 AAP
Figure 13. Extron AAP 301 Frame Mounted Directly to a Rack
2. Attach all power and video cables to the rear of the transmitter/receiver. Power on the
transmitter/receiver now if the external power supply cannot be accessed once the
transmitter/receiver is mounted.
3. Attach the video input and output devices to the front faceplates of the transmitter and
receiver, respectively. Power on all devices.
VTT001 and VTR001 User Guide • Installation 16