Cabling and setup – Extron Electronics VTR001 User Guide User Manual
Page 12
Cabling and Setup
To install the VTT001 MAAP and VTT001 models and the VTR001 MAAP, VTR001 AAP, and
VTR001 models, follow these steps:
1.
Turn all of the equipment off and, if applicable, disconnect it from the power source.
2.
Connect the RJ-45 connectors of the transmitter and receiver to either end of the
twisted pair cable (see
on page 8 and
on
page 9).
NOTE: RJ-45 termination must comply with the TIA/EIA T568A or TIA/EIA T568B
wiring standards for all connections, as shown below.
RJ-45
Connector
1&2
3&6 4&5
7&8
Twisted Pairs (4)
12345678
Pins:
Pin
RGB Video
Signal
1
Red/V. sync +
2
Red/V. sync -
3
Power
4
Green +
5
Green -
6
Power
7
Blue/H. sync +
8
Blue/H. sync -
Wire color
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
Wire color
TIA/EIA T568A
TIA/EIA T568B
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
Figure 5.
RJ-45 Pin Terminations
NOTES:
•
For best results, use Extron Skew-Free AV UTP cable, available in bulk or
in various pre-terminated lengths. If necessary, regular CAT 5 cable may
be used. CAT 5e and CAT 6 cables are not recommended.
•
If you are using Enhanced Skew-Free AV cable, use the TIA/EIA T-568-A
standard only.
3.
Connect the external power supply to the transmitter, the receiver, or both. Both
transmitter and receiver have remote power capability. For transmission distances up
to 300 feet, the applied power is only required at either the transmitter or the receiver.
Greater distances require power to be applied locally to both transmitter and receiver.
4.
Connect an output display device to the 15-pin HD video output connector of the
receiver.
5.
Connect a RGBHV/RGBS video source to the 15-pin HD video input connector of the
transmitter.
6.
Power up the video input and output devices, then apply power to the power supply
and test for the display output. Adjust the sharpness, if necessary (see
on page 9). If a problem is encountered, check all connections before
proceeding further.
7.
If the previous display test was successful, power off and disconnect all equipment,
detach all cables, and install the mountable transmitter or receiver (see
on
page 10).
VTT001 and VTR001 User Guide • Installation
7