Extron Electronics VTR001 User Guide - Manual (Page 18)

Wall bracket mounting
1. Attach the transmitter/receiver modules to the mounting frame with the included #4-40
screws.
2. Attach all power and video cables to the rear of the transmitter/receiver. Power on the
transmitter/receiver now if the external power supply cannot be accessed once the
transmitter/receiver is mounted.
3. Attach the mounting frame (with the attached transmitter/receiver modules) to the
mounting bracket using the two included mounting screws.
VTT001 Wall Mounting w new Bracket.eps
Extron
CPM101
Mounting Frame
Extron
70-163-xx
Wall Mounting Bracket
Extron
VTT001 MAAP
Twisted Pair
Transmitter
VT T0 01 MA AP
PO WER
INPUT
Backing Clip
VT T0 01 M AA P
Figure 9. Attaching the Mounting Frame to the Wall Mounting Bracket
4. Attach the video input and output devices to the front faceplates of the transmitter and
receiver, respectively.
5. Power on all devices.
VTT001 and VTR001 User Guide • Installation 13