Extron Electronics VTR001 User Guide - Manual (Page 10)

CAUTION: Do not tin the stripped power supply leads before inserting them into
the captive screw connector. Tinned leads are not as securely attached as
untinned leads and could slip out.
NOTE: Both transmitter and receiver have remote power capability. For
transmission distances up to 300 feet, the power is required only at either the
transmitter or the receiver. Greater distances will require power to be applied to
both transmitter and receiver.
É
Power input jack — Connect the included 12 VDC external power supply to this
female jack. The VTT001 and the VTR001 use this power input connector (see the note,
cautions, and warning for
Ç above).
The male power plug that connects to this input jack is shown below.
Power Connector wiring.eps
Tip (+) Sleeve Tip (+)
Sleeve
Power plug
VTT001 and VTR001 User Guide • Installation 5