Extron Electronics VTR001 User Guide - Manual (Page 17)

Wall box mounting
1. Attach the transmitter/receiver modules to the mounting frame with the included #4-40
screws.
2. Attach all power and video cables to the rear of the transmitter/receiver. Power on the
transmitter/receiver now if the external power supply cannot be accessed once the
transmitter/receiver is mounted.
3. Attach the mounting frame (with the attached transmitter/receiver modules) to the wall
box, using the two included mounting screws.
Wall opening
flush with
edge of box
VTT001 install in wall box.eps
VT T0 01 MA AP
PO WER
Extron
CPM101
Mounting Frame
VIDEO INPUT
VT T0 01 M AA P
Figure 8. Attaching the Mounting Frame to the Wall Box
4. Connect the video input and output devices to the front faceplates of the transmitter
and receiver, respectively.
5. Power on all devices.
VTT001 and VTR001 User Guide • Installation 12