Warner Electric MCS-131 - Manual (Page 5)

Interface Programming
The two optional logic modules provide for expanded input switching of the basic control. Logic board
selection will be dependent primarily upon the input switching requirements. For most applications, the
bag logic module will be the more suitable.
Board Set Up and Programming
A. Bag Logic Board, 6040-448-016
Switch No. Function Affected Control Operation
SW 1 Stop Open: Pulse Control on terminal 7. Triggers on negative
transition of input pulse.
SW 2 Photo Input Closed: Dark Operation, switches
SW 3 Open: On negative transition
SW2 Photo Input Open: light Operation, switches
SW 3 Closed: On positive transition
SW4 Start Open: Pulse Control on terminal 1. Triggers on negative
transition of input pulse.
Closed: Level input on terminal 1. Active low, triggers on
negative transition of input.
Using the Bag Logic Module, 6040-448-016, control input terminal designations change somewhat as
shown in Figures 3 and 4.
Terminal No. Function Control Input Logic
1 Start Selectable on Card for Level or Pulse
2 Photo Inhibit Level only, Active Low
7 Stop Selectable on Card for Level or Pulse
8 Photo Input Level, Light/Dark Card Selectable
For waveform timing diagrams, see Figure 5.
Warner Electric • 800-825-9050 P-262 • 819-0493 4