Vestil EM1 series User Manual
Page 11
03/05
03-126-120.doc
V
ESTIL
M
FG
.
C
O
11
H
YDRAULIC
D
IAGRAM
–
L
IFT
-H
OLD
-L
OWER CIRCUITS
o
Warning: Care should be taken to identify all potential hazards and comply with applicable safety procedures before
beginning work. Ensure that all system pressure and power have been removed before attempting to work on the
electrical or hydraulic systems.
o
Warning: The load must be removed, and the platform either positively and adequately supported or fully tilted,
before any work is performed on the tilter.
o
Only qualified individuals trained to understand mechanical devices and their associated electrical and hydraulic
circuits should attempt troubleshooting and repair of this equipment.
o
Caution: Do not use brake fluid or jack oils in the hydraulic system. If oil is needed, use an anti-wear hydraulic oil
with a viscosity of 150 SUS at 100°F (ISO 32 @ 40°C), or non-synthetic transmission fluid.
Model EM1-200
Models EM1-500, EHTT, EHTT-L