Vanguard WRM-40 - Manual (Page 37)

REV 3 WRM-10P AND WRM-40 USER’S MANUAL
33
o. The following screen will be displayed after the last “Raise” position’s resistance reading
is stored:
1. YES
Press the
[1]
key (YES) to print the test results on the built-in thermal printer. A
Typical LTC/Voltage Regulator test report is shown in Figure 14. Continue to step
p.
2. NO
Press the [2] key (NO) to bypass printing of the test results. Continue to step p.
p. The following screen will be displayed:
1. YES
Press the
[1]
key (YES) to save the test record. The following screen will be
displayed:
Press any key to return to the “START-UP” menu.
2. NO
If you do not wish to save the test record, press the
[2]
key (NO). The following
screen will be displayed:
Press the
[1]
key (DO NOT SAVE RECORD) to NOT save the test record. You will
be returned to the “START-UP” menu.
RECORD NUMBER 01
HAS BEEN SAVED!
ARE YOU SURE?
DATA WILL BE LOST!
1. DO NOT SAVE RECORD
2. SAVE RECORD
SAVE THIS RECORD?
1. YES
2. NO
PRINT RECORD?
1. YES
2. NO