Vanguard LTCA-10_40 User Manual
Page 24
LTCA-10/LTCA-40 USER’S MANUAL
24
l. The “PRINT TEST RESULTS?” menu will be displayed:
1. YES
Press the
[1]
key (YES) to print the test results on the built-in thermal printer. The
last test results displayed on the LCD screen will be printed. Typical LTCA-10/40
test reports are shown in Figure 7.0, Figure 8.0, and Figure 9.0. Continue to step
m.
2. NO
Press the
[2]
key (NO) to bypass the printing of the test results. Continue to step
m.
m. The “KEEP THIS READING?” menu will be displayed:
1. YES
If you wish to save the reading, press the
[1]
key (YES). One of the following
screens will be displayed:
The following screen will be displayed if there is no previous data in the memory:
The following screen will be displayed if previous data for the same test type is
stored in the memory:
The LTCA-10/40 retains the current test results in its working memory. When a
test is finished, the user can append the new test results to the previous test results
in the working memory, as long as the unit’s power has not been turned off
between tests.
If data exists in the working memory, you will be presented with the “PREVIOUS
DATA IN BUF?” menu shown above. Press the
[1]
key to append the current test
results to the previous test results in the working memory. Press the
[2]
key to
PREVIOUS DATA IN BUF?
03/01/09
10:30
1. APPEND PREV DATA?
2. CLEAR PREV DATA
=====> TEST SAVED! <=====
KEEP THIS READING?
1. YES
2. NO
PRINT TEST RESULTS?
1. YES
2. NO