TREND TB_TI - Manual (Page 3)

TB/TI Thermistor Insertion Temperature Sensor Installation Instructions TG200727 Issue 1/E 11/07/07 3
Installation Instructions TB/TI
Installation (continued)
Install Immersion Sensor
3
a2
a3 (if installing new pocket)
b *Install Sensor into Pocket
a
Drill hole for boss Fix threaded boss
*Screw pocket into boss
½” BSPT
threaded boss
apply sealent to
boss thread
If using compatible pocket
use 2 mm hexagonal socket key
tighten screws
Install Pocket
a1
c1
If using Universal Fitting Kit
Push adaptor onto probe Adjust probe length
*Mount in pocket
if pocket has grub screw, discard spring and clip
clip
spring
brass brush
tighten
use 2 mm
hexagonal socket
key
pocket
length
clip engages in groove
probe is forced
against end of
pocket
tighten screw over bush
c Install Sensor into Pocket
c3
c2
if pocket has clip retaining groove, push
clip over pocket
*If used for chilled water ensure pocket is sealed around probe or fill pocket with thermally
conducting oil to avoid the build up of condensation in bottom of pocket.
use M27 Spanner