TREND XW_R_IQ - Manual (Page 4)

XW/R/IQ Installation Instructions
XW/R/IQ Wireless Sensor Receiver Installation Instructions TG200783 Issue 1/B 16/01/07 4
Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Ecublens, Route
du Bois 37,Switzerland by its Authorized Representative.
Trend Control Systems Limited reserves the right to revise this publication from time to time and make changes to the content hereof
without obligation to notify any person of such revisions or changes.
Trend Control Systems Limited
P.O. Box 34, Horsham, West Sussex, RH12 2YF, UK. Tel:+44 (0)1403 21888 Fax:+44 (0)1403 241608 www.trend-controls.com
Trend Control Systems USA
6670 185th Avenue NE, Redmond, Washington 98052, USA. Tel: (425)897-3900, Fax: (425)869-8445 www.trend-controls.com
Connect receiver to controller 8
either for IQ3 or current IQ2xx (excluding IQ251)
Test System 9
IQ
Δ T
e.g. TB/TI/..
XW/R/IQ
INSTALLATION (continued)
or IQ251 and older IQ2xx’s without 24 V on local supervisor port
100-240 V
OK RX
local supervisor port
RJ11
local
supervisor
port
RJ11
24 Vdc Aux
Note XW/R/IQ current consumption <= 50 mA
Configure IQ controller strategy 7
1 Check compliance with step 2 sections C & D
2 Move sensor or receiver slightly in case of a standing wave null position
current IQ2xx (not IQ251)
or IQ3
IQ251
or older IQ2xx’s
If there is reception failure of sensor 6
For IQ3 the sensor’s target analogue node must be created
using SET. An example strategy including decoding of
alarm bits is given in the TW/.., XW/R/IQ data sheet
TW/.., XW/R/IQ
Data Sheet
TA200780
WEEE Directive:
At the end of their useful life
the packaging, product, and
batteries should be disposed
of by a suitable recycling
centre.
Do not dispose of with normal household waste.
Do not burn.
DISPOSAL
cable: RD/SDU-ADAPTOR IQ2xx