TREND NXIP - Manual (Page 3)

NXIP Installation Instructions TG200827 Issue 1/D 15/1/07 3
Installation Instructions NXIP
O
I
3 INSTALLATION
(Continued)
Connect Ethernet 7 Switch on Power to NX Drive 8
Connect to an Ethernet hub
Use Ethernet cable .
IQ System Products
Engineering Guide TE200369
NXIP
RJ45 Connector
RJ45 Connector
100 m (109 yds)
Ethernet hub/Switch
Connect to NXIP with IP Tool and SET 9
Either over Ethernet Network or Local PC Ethernet Connection
Initially access NXIP using it MAC address
(written on label).
Note that a device with a virtual CNC (e.g.
IQ3 or 3xtend/EINC L) in supervisor mode
is required for SET to access the NXIP
over the Ethernet network.
Local PC (Ethernet) connection can be
either to adjacent Ethernet hub using
standard cable only, or directly to NXIP
using standard cable and crossover
adaptor, XCITE/XA.
SET Manual TE200147
IP Tool Manual TE200638
SET and IP Tool
SET and IP Tool
Router
NXIP
IQ3 or
3xtend/EINC L
XCITE/XA crossover adaptor order
seqarately (XCITE/XA/5 pack of 5)
IMPORTANT
NXIPs do NOT support automatic addressing, and MUST NOT be installed on an Ethernet
network where automatic addressing is being used.