Edit variables, Figure 3 - variable setup tab – Teledyne LeCroy QPHY-PCIe3-Tx-Rx User Manual

Page 14

Text mode
Original mode

923662 Rev B

Edit Variables

The Variable Setup tab contains a list of test variables. See

QPHY-PCIE3-TxRx Variables

for a

description of each.

To modify a variable:

1. Select the variable on the Variable Setup tab, then click Edit Variable. (You can also

choose to Reset to Default at any time.)

Note: Especially check the SigTest Path variable. The default value for this variable is
SigTest.exe ver. 3.2.0, which is currently the version required by the PCI SIG. It is
available for download from the PCI SIG website.

2. The conditions of this variable appear on a pop-up. Choose the new condition to apply.

Figure 3 - Variable Setup tab.