Teledyne LeCroy USB Analyzer Automation Manual - Manual (Page 140)

Teledyne LeCroy Automation API Reference Manual for USBTracer, USB Advisor, and Voyager USB Protocol
Suite
140
Set The Analyzer Commands to Execute on the Host Controller
The last configuration step is to set the "launch" location to Server for commands. This setting tells the
client to execute commands remotely on the DCOM server rather than on itself.
1. On the Distributed Configuration Properties dialog box, click the tab marked Default Properties.
You should see the following settings. If the settings are not the same as those shown,
change them to match the screenshot.
2. Select the option Enable Distributed COM on this computer.
You must perform this step on both computers - the DCOM server and DCOM client.