Teledyne LeCroy ZD200 - Manual (Page 8)

ZD200 Differential Probe
2 922182-00 Rev A
Do not operate with suspected failures. Do not use the probe if any part is
damaged. Cease operation immediately and sequester the probe from
inadvertent use.
Operating Environment
The accessory is intended for indoor use and should be operated in a clean, dry
environment. Before using this product, ensure that its operating environment is
maintained within these parameters:
Temperature: 5° to 40° C.
Humidity: Maximum relative humidity 90 % for temperatures up to 31° C
decreasing linearly to 50 % relative humidity at 40° C.
Altitude: Up to 10,000 ft (3,048 m).
Introduction
The ZD200 Differential Probe is ideally suited for automotive and serial data
signals. The wide dynamic range (+/- 20V differential) and 1 MOhm input
resistance make the ZD200 ideally suited for a wide range of applications.
The ZD200 probe can be used with Teledyne LeCroy’s WaveSurfer, WaveRunner,
WavePro, and WaveMaster series platforms with firmware version 6.4.1.x or
later.
With the ProBus interface, the ZD200 probe becomes an integral part of the
oscilloscope. The probe can be controlled from the oscilloscope’s front panel.
The oscilloscope provides power to the probe, so there is no need for a separate
power supply or batteries.