Teledyne LeCroy HDO 6000 Getting Started Guide - Manual (Page 30)

923011-00 Rev A
BASICS 26
Choose a standard
Logic Family, or
enter custom values
for Threshold and
Hysteresis. Separate
controls allow you to
set different values for
each bank.
Digital Traces From the Display
Touch to activate the digital trace and
again to open the Digital dialog.
Touch tab to choose digital group (1-4).
Choose to display individual digital lines, bus trace or both.
Touch arrows to switch between banks 0-7 and 8-15.
Touch checkbox to select the lines in the group.
Enter Vertical Position (top of lowest bit relative to center) and Group
Height (vertical space occupied by group) in divisions.
Watch Line Activity Indicators instead of line traces to quickly see the
state of each digital line.
Touch to open Logic Setup dialog.
A
B
C
D
E
F
G
A
B
C D
E
F
G
Transitioning High Low
Line Activity Indicators
Line trace shows high, low and transition points for each line.
Bus trace collapses lines into hex values.