Teka HPL 870 - Manual (Page 47)

47
ENGLISH
Cancelling the pyrolytic cleaning cycle
To cancel the pyrolytic cleaning cycle,
remember:
a) Cold oven:
– Switch off the oven by touching sensor
.
– You will see the time remaining until the
door unlocks on the clock display.
– When display shows 00:00 and the
symbol turns off, you will be able to
open the oven door.
b) Hot oven:
– Switch off the oven by touching sensor
.
– The time 00:00 will be shown on the
clock display.
– The oven’s cooling motor will continue to
operate and the symbol will be lit up.
– When the electronics detect that the
oven is cold, you will see the time
remaining until the door unlocks on the
display.
Problems when operating the pyrolytic function
PROBLEM CAUSE SOLUTION
My accessories and shelf
suppor ts are damaged. You have not removed the
accessories and suppor ts
during the pyrolytic cleaning
cycle. You must replace them and
remove them in later
cleaning cycles.
The enamel colour has
changed or stains have
appeared. The chemical composition
of some foodstuffs may
cause changes in the
enamel. This is normal and does not
damage the proper ties of
the enamel.
A flashing symbol indicating
” will appear on the
temperature display and an
alarm will sound.
The oven is programmed
to run a pyrolytic cleaning
cycle but the door is open. Close the door to enable the
function to be run.
I have programmed the
pyrolysis function, the oven
is working properly but the
symbol
is not lit up.
Indicator light does not
work properly.
Call the Technical Assistance
Ser vice.
The pyrolytic programme has
finished but the oven door is
locked. The oven has not cooled
down to the safe
temperature. Wait until the oven cools
down and the symbol
turns off.
3172493-000 EPIFA.QXD:- 30/9/11 08:59 Página 47