Steelcraft Automotive 220700 3 ROUND SIDE BAR - Manual (Page 2)

SIDEBAR
02-07 JEEP LIBERTY
Page 2 of 3 6-25-12 Rev1 (DP)
Front
6. Move toward the rear of the vehicle. Verify that exhaust is completely cool before continuing.
7. Insert (1) 1/2
” Bolt Plate through the factory oval hole in the bottom of the frame rail and out through the
hole in the inner wall of the frame channel, (Figure 7). Thread (1) 1/2" Plastic Retainer onto the
threaded end of the Bolt Plate until it is tight against the frame rail as described in Step 2. Select the
passenger side rear Mounting Bracket. Hang the Bracket from the Bolt Plate with the included (1) 1/2
”
Lock Washer, (1)
1/2” Flat Washer and (1) 1/2” Hex Nut. Rotate the Bracket up and over the factory
12mm stud located in the floor panel towards the center of the vehicle. Attach the Bracket to the stud
using the included (1) 1/2
” Flat Washer and (1) 12mm Hex Nut, (Figure 7). Do not tighten hardware.
8. Carefully position the passenger Sidebar onto the Mounting Brackets. Attach the Sidebar to the
Mounting Brackets using the included (4) 8mm x 25mm Hex Bolts, (4) 8mm Lock Washers and (4)
8mm Flat Washers, (Figure 6). Do not tighten hardware at this time.
9. Align Sidebar properly and tighten all hardware.
10. Repeat Steps 2 - 9 for driver Sidebar installation. NOTE: Driver side rear Mounting Bracket bolts to the
outer wall of the frame channel, (Figure 8).
11. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Passenger Side Installation Pictured
1/2 ” Bolt Plates
1/2" Plastic Retainers
Use for all Bolt Plate
installations
Fig 1
Fig 2
Fig 3
1/2 ” Bolt Plate
1/2" Plastic Retainer
1/2” Lock Washer
1/2” Flat Washer
1/2” Hex Nut
(2) 1/2 ” Bolt Plates
(2) 1/2" Plastic Retainers
(2) 1/2" Lock Washers
(2) 1/2” Flat Washers
(2) 1/2” Hex Nuts