Steelcraft Automotive 202220 3 ROUND SIDE BAR - Manual (Page 2)

3" SIDE BARS WITH BENT ENDS
2001-2011 SILVERADO/SIERRA CREW CAB
Page 2 of 3 1/24/11 Rev1(DP)
6. Level and adjust the Side Bar, tighten all hardware and check all mounting locations for clearance
between factory steel body mount brackets and Mounting Brackets. Once satisfied with fit, tighten all
hardware.
7. Repeat steps 2-6 for passenger Side Bar installation.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap may be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Driver side installation pictured
(Fig 1) Front Mounting Location
Factory hex bolt
Front
1/2” x 2” Hex Bolt
1/2” Lock Washer
1/2
” Flat Washer
(Fig 4) Rear Mounting Location
Factory hex bolt or replace with:
12mm x 120mm Hex Bolt
12mm Lock Washer
12mm x 32mm OD Flat Washer
Rear
10mm x 25mm Hex Bolt
10mm Lock Washer
10mm Flat Washer
(Fig 3) Center Mounting Location
Factory hex bolt
Front
Fig 2
Factory welded steel body mount bracket