Steelcraft Automotive 155110 RUNNING BOARD - Manual

VIEWPOINT RUNNING BOARDS
2009-13 HONDA PILOT
Page 1 of 5 2-13-13(DP)
PARTS LIST:
1 Driver side running board 1 8mm Insert Installation Tool
1 Passenger side running board 4 10-1.50mm x 35mm Hex Bolt
1 Driver Front Mounting Bracket 10 10mm x 24mm OD x 2.2mm Flat Washer
1 Passenger Front Mounting Bracket 6 10mm Lock Washer
1 Driver Front Support Bracket 6 10-1.50mm Hex Nut
1 Passenger Front Support Bracket 12 8-1.25mm x 25mm Hex Bolt
1 Driver Center Mounting Bracket 12 8mm Lock Washer
1 Passenger Center Mounting Bracket 12 8mm x 22mm x 2mm Flat Washers
1 Driver Rear Mounting Bracket 12 6-1.0 x 20mm T-Bolts
1 Passenger Rear Mounting Bracket 12 6mm x 22mm OD x 2mm Flat Washer
2 10-1.50mm x 40mm Bolt Plate 12 6mm Lock Washer
2 8-1.25mm Threaded Insert 12 6-1.0mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting on the driver side of the vehicle, locate the two factory 8mm threaded holes, one
located in the bottom of the floor panel and the second in the side of the inner body panel,
(Figure 1). IMPORTANT: All factory threaded holes may be covered with rubber plugs or
undercoating. Scrape off any excess undercoating from mounting surfaces.
3. Select the driver side Front Mounting Bracket. Attach the Bracket to the two threaded holes
using the provided (2) 8mm x 25mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat
Washers. Snug but do not tighten hardware at this time, (Figure 2).
Passenger/Right
Rear Mounting
Bracket Driver/Left Rear
Mounting
Bracket
Driver/Left Front
Support Bracket Passenger/Right
Front Support
Bracket
Passenger/Right Front
Mounting Bracket
Driver/Left Front
Mounting Bracket
Rear
Front
Driver/Left Running Board
Passenger/Right Running Board
(2) 10mm Bolt Plate
Passenger/Right Center
Mounting Bracket Driver/Left Center
Mounting Bracket