Steelcraft Automotive 70400 SPORT BAR - Manual (Page 2)

SPORT BAR
2010 EQUINOX/TERRAIN
Page 2 of 4 8/17/10 (DP)
6. Center and align the Sport Bar. Once absolutely satisfied with the fit and alignment, tighten the 10mm
hardware securing the Frame Mounting Brackets to the radiator brackets. Remove the Sport Bar.
7. Temporarily reinstall the air dam. Find the center of the spoiler by locating the molding ID mark on the
back-center of the spoiler, (Figure 6). Measure outward from the center mark to the inside of the driver
side and passenger side mounting brackets to verify that the Sport Bar is centered on the vehicle,
(Figure 7 & 8). This measurement will be the centerline of the slots to cut through the spoiler.
8. Use a felt marker or paint pen to mark a vertical line representing both mounting bracket locations onto
the back of the plastic spoiler, (Figure 7), with top and bottom of Bracket indicated. Remove the spoiler
and place it on a clean, stable work surface. Measure from the center of the spoiler, (ID mark), outward
the distance measured in Step 7, (Figure 8). Use the previously marked line for a vertical reference
and draw a parallel line at the measured distance, (Step 9). NOTE: Check all measurements before
continuing.
9. Drill a 1/2" hole at the top and the bottom of the measured line, (Figure 10). Use a sharp utility knife or
hacksaw to cut a 1/2" wide slot for the Mounting Brackets, (Figure 11). NOTE: Additional trimming for
Sport Bar clearance may be required on Equinox model vehicles. IMPORTANT: To maintain the
integrity of the spoiler, do not cut completely through the top or bottom edge of the spoiler. Only remove
material required to clear the Sport Bar.
10. Reinstall the spoiler using the factory hardware and clips. Hold the Sport Bar up in position to check for
clearance. Trim plastic as necessary.
11. Insert the Sport Bar through the air dam and bolt it to the Mounting Brackets with the hardware listed in
Step 5, (Figure 12).
12. Level and adjust Sport Bar properly and tighten all hardware.
13. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap may be used also to clean the Sport Bar.
For gloss black finishes: Mild soap may be used to clean the Sport Bar.
Driver Side Mounting Bracket Installation Pictured
Clips
Screws
Fig 1
Fig 2
Mounting Bracket
(2) 10mm x 35mm Hex Bolts
(4) 10mm Flat Washers
(2) 10mm Lock Washers
(2) 10mm Hex Nuts
Front
Front