LevelOne VOI-8001 - Manual (Page 24)

2
 Current Drop-> 3 S: Enable FXS interface to generate three seconds
Current Drop signal.
C. Called Number Relay on FXS ：
Define when use the FXS interface to outbound call, resend or Drop out the
dialed number.
 Drop out: Do not send the dialed number. When use the FXS port
direct connect to phone set for outbound call, please enable the
“Drop out” function to avoid hear the unnecessary dialed number
when answer the phone call.
 Resend: Resend the dialed number. When use the FXS port to
connect to PBX line for outbound call, please enable the “Resend”
function to redial the destination number by DTMF, this will cause the
PBX transfer to the call to the final user.
D. Caller ID Generate type:
Define the Caller ID (CID) signal generate format:
 Disable: Disable, do not send CID signal.
 DTMF: Send CID signal by DTMF format.
 FSK Bell: Send CID signal by FSK Bell format.
 FSK ETSI: Send CID signal by FSK ETSI format.
E. Caller ID Detect Mode：
Define the CID detect format of FXO interface:
 Disable: Disable, Do not detect any CID signal
 DTMF: Enable detect CID signal by DTMF format.
 FSK Bell: Enable detect CID signal by FSK Bell: format.
 FSK ETSI: Enable detect CID signal by FSK ETSI: format.
F. When VoIP call out, send ANI by:
Define when VoIP call out, use the below number as the Caller ID (ANI):
 Register Number: Use the gateway register number as ANI.
Line Number: Use the line number setting on the /VoIP
Setup/Line Configure/Line Setting/ as ANI.
 PSTN CID: Use the received Caller ID number from PSTN line as
ANI.
G. FXS Ring Method：
Define how the FXS interface to ring the phone line when VoIP call in:
 Free Random: Any unused available line.