King Electric SRK08 GFEP device kit User Manual
Page 13
Rev 11.04.12
www.king-electric.com
13
5
6
Notch the conductive core at the end and twist it back
to peel the bus wires from the core.
Score between the bus wires and bend the core to
break it free and peel the core material away from the
bus wires.
7
8
Slide the 1/8” dis. X 1” heat shrink tube over the bus wires.
Apply heat to shrink the tubes, approximately 2 minutes at
600ºF (315ºC). Keep tubes up against the core while heat
shrinking.
9
Heat evenly for approximately 3 minutes at 600ºF
(315ºC) until it shrinks completely.
10
Cut and remove the remaining center core, leaving the
bare conductors.
Center the 1/2” x 1” heat shrink tube over the cable core
and bus wires as shown.
See also other documents in the category King Electric Accessories for electrical:
- SRK00 pipe mount kit (16 pages)
- SRK02 connection kit (7 pages)
- SRK10 splice/tee kit (8 pages)
- SRK12 end-seal kit (2 pages)
- SRK13 roof clip (2 pages)
- SRK15 downspout hanger (2 pages)
- SST 2 (14 pages)
- SST 3 (28 pages)
- GPT 3 (21 pages)
- LCD-7A (2 pages)
- N.E.M.A.4X TF115 (2 pages)
- DS-824 (4 pages)
- DS-8 (4 pages)
- DS-2B (4 pages)
- CDP-2 (2 pages)
- TH115-AF-GA Electronic Programmable (76 pages)
- TH114-AF-GA Electronic Non-Progrm (2 pages)
- TH115-AF-12VDC Electronic Progrm Master (4 pages)
- FCS13 heating cable repair kit (4 pages)
- FCS11 Instant Alert Monitor (2 pages)
- F802GFCI Electronic Programmable (6 pages)
- FCM Floor Mat (19 pages)
- SRP self-reg, preassembled (6 pages)
- CWP (4 pages)
- SC (20 pages)
- TC (11 pages)
- ES Electronic (3 pages)
- ESP Electronic Programmable (4 pages)
- ECP2P Electronic Programmable (4 pages)
- HE Anticipated (2 pages)
- K601C-25 Heat or Cool (2 pages)
- WR Window Watcher (4 pages)
- K101 (3 pages)
- HWP120 Electronic Programmable (1 page)
- Transformer Silent Relay (3 pages)
- Transformer Silent Relay (1 page)
- Bi-metal Sensor Thermostat (1 page)
- Capilary Tube Thermostat (1 page)