Inter-M HDRC-Z440 - Manual (Page 16)

Hold down the CTRL key while selecting the desired scene using the Joystick. Current position will be
displayed. Release CTRL key to complete. Or Press IRIS Open then the “CTRL” displays. Move the desired
position and the zoom position. Press IRIS Close then the “CTRL” disappears. Select Exit and push the
Joystick to the right.
3.6 Shortcut of Preset Program
After selecting the desired scene, press No. (1 to 240), and press CTRL and PRST subsequently. The current
view will be stored to the selected preset number if the preset number is empty. If selected preset number is
not empty, “OVER WRITE” message will be displayed on the monitor and select the “OK” and push the
Joystick to the right to overwrite.
Example: 1 , 0 , 1 + CTRL + PRST will store current view as preset No. 101. In this case, focus will be
programmed as Auto, dwell time will be set to 3 second, and the current AE mode will be programmed.
3.7 Tour
(SHORTCUT: TOUR)
There are 8 programmable Tours. Each Tour consists of up to 42 Preset positions, Patterns, Scans or other
Tours (second-level). Using second-level tours, it can be expanded to over 300 functions in a single tour.
--- : blank position
SCAN TYPE : NORMAL/ VECTOR
DWELL : 03-99 Sec
003 : Preset (1~240)
A08 : Auto Scan (1~8,10~17)
P01 : Pattern (1~8)
T02 : Tour (1~8)
TOUR SETUP
NUMBER : 01
TITLE : T01
SCAN TYPE : NORMAL
SPEED : 5 STEP
TOUR FUNC
SAVE AND EXIT
TOUR FUNC SETUP
DWELL : -- SEC
003 A08 --- --- ---
--- --- --- --- ---
--- --- P01 --- ---
--- T02 --- --- ---
--- --- --- --- ---
--- --- --- --- ---
--- --- --- --- ---
--- --- --- --- ---
EXIT