Harrington Hoists and Cranes TCR Hoist - (1/4-6 Ton) User Manual

Page 39



Invert the hoist such that the chain separator openings are facing up. The

chain must be inserted into the chain separator on the no load side opening. This is where the no
load end of chain attaches to hoist body. Without inserting the load chain, operate the hoist
pendant or cord control to determine which direction the load sheave is rotating in relation to the
pendant control function pressed or pulled. Install load chain into the hoist making certain the first
link is a standing link and that its weld is facing away from the centerline of the hoist. See

Figures

7-3

and

7-4

below.

Figure 7-3

Load Chain Installation Diagram



Operate the hoist slowly to catch and pull the chain through the hoist. Make

sure the chain feeds smoothly while operating the hoist. If binding occurs, stop and reverse the
hoist direction to back the chain out. Reinsert the chain while gradually operating the hoist
controls. Continue until sufficient quantity of chain is fed through the hoist.

Table 7-1

Placement of Stoppers on Load Chain

Model Type Hoist

Version 1, A & B

Version C

Load Side Chain End

No Load Side Chain End

Load Side Chain End

No Load Side Chain End

TCR250P, C
TCR500P, C
TCR1000P, C

None

TCR1000P2, C2

TCR2000P2, C2

TCR3000P, C
TCR6000P2, C2

None