Harrington Hoists and Cranes CF Hand Chain Hoist - Manual (Page 29)

29
Figure 6-5 Chain Guide Assembly
12) Clean and grease ball bearing A [15] and D [17-A] and insert into body A [10] (if being replaced).
13) Put the body A [10] with the ball bearings [15, 17-A] side down on the body B [11].

: Make sure each part is completely set between body A [10] and frame [13].
14) Insert four socket bolts [22, 22-A] into the body A [10] and turn the whole body sideways. Then fix
the bolts with the U nuts [23] holding the U nuts with fingers.

: Insert short socket bolts [22-A] to the upper holes and long socket bolts [22]
to the lower holes.
Figure 6-6 Body “A” Assembly
15) Insert pawl pin [24] into the body A [10] and fix it with the U nut [25].
16) Apply machine oil to the pawl pin [24] and join pawl spring [26] and the pawl [27] respectively to it.
Fix the pawl with snap ring [28].

: Make sure the pawl spring is fixed to the pawl and the snap ring is securely set
at the groove of the pawl pin.