Gilderfluke&Co Analog Output Smart Brick (ver 2.nn w/Eprom memory) User Manual

Page 14

The Eprom file that PC¥MACs generates will have the extension of filename.Mnn. The 'M' in the exten-

sion flags it as a 'multiple channel' Eprom file. The 'nn' is the HEXadecimal address of the first channel in
the Eprom set. Once saved, this file can be burnt into any Eprom from 1 Mbit (27C010) to 8 Mbits
(27C080). The BS-ANA supports all four standard thirty-two pin Eproms.

The address of the data sent out from an Eprom may be different from what you saw when program-

ming through the DMX-512 input. This is a question of the address selected for the BS-ANA and whether it
is addressed via the front panel switches or the software. Data sent out from the Eprom will be sent out
starting at DMX-512 and Z-Brick outputs 00h. The BS-ANA DMX-512 address should be addressed at 00h
(either using the front panel dipswitch or software address setting) to make sure the addresses are the
same when running from DMX or the on-board Eprom.

ILDERFLUKE

& C

.¥ 205 S. F

LOWER

. ¥ B

URBANK

, CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥

FAX

818/840-9485

10 of 24