Sonnet Technologies Tempo Ultra ATA66 Host Adapter - Manual (Page 36)

6-4
Mount Drive to Drive Carrier or Sled
1. Using a small flatblade screwdriver or a
needle nose plier, properly configure the hard
drive jumper pins. For further information
on jumper pin settings, see Chapter 2,
“Configuring Your Hard Drive.”
2. Depending on your computer model, mount
the new drive to either the single drive carrier
or drive sled with appropriate screws. Attach
the primary/master connector on the Ultra
ATA66 cable to the hard drive; if you are unfa-
miliar with the Ultra ATA66 cable connectors,
see page ix, for further information. Figure 8
illustrates a new drive with attached Ultra
ATA66 cable mounted onto a drive sled.
3. Reinstall the drive carrier or drive sled into the
computer and attach a drive power connector
to the new drive. The internal hard drive’s
power cable should have an additional power
connector. If disconnected earlier, reconnect
the logic board power bundle and internal
hard drive ribbon cable to the logic board.
Your system should appear similar to what is
shown in Figure 9 after everything is
reinstalled and reconnected.
Figure 8
Figure 9
internal hard drive
ribbon cable
power cord
bundle
internal
hard drive
new IDE
hard drive