Sonnet Technologies Tempo Ultra ATA66 Host Adapter - Manual (Page 15)

5. Configure the hard drive with appropriate
jumper pin settings. If necessary, use a small
flatblade screwdriver or needle nose pliers to set
the jumper pins. (See Chapter 2, “Configuring
Your Hard Drive” for further information.)
6. Attach the primary/master connector of the
Ultra ATA66 cable to the hard drive. (See
page ix, “Identifying Ultra ATA66 Cable” for
further information.)
7. Depending on your computer model,
mount the hard drive to a drive mounting
bracket/carrier (Figure 1) or a drive sled
(Figure 2). You may require a medium
Philips screwdriver to perform the installation.
If necessary, refer to your computer’s user guide
for specific information on the installation
of internal storage devices.
8. Install the hard drive into an expansion bay.
9. Attach a power cable connector to the hard
drive (there should be an additional
connector on the existing internal hard
drive’s power cable).
10. Locate an available PCI slot and remove
its access port cover (if present).
1-3
Drive Mounting
Bracket/Carrier
Figure 1
Drive Sled
Figure 2