Sonnet Technologies Tempo Ultra ATA66 Host Adapter - Manual (Page 28)

4-4
3. Align the Tempo over the PCI slot (Figure 9).
Gently press down until it is firmly seated into
the PCI slot, taking care not to wiggle the
board as you install it into the slot.
4. Attach the host connector on the Ultra ATA66
cable to the connector closest to the bracket on
the Tempo (Figure 10); if you are unfamiliar
with the Ultra ATA66 cable connectors, see
page ix, for further information.
Close Computer
1. Carefully position the Ultra ATA66 cable inside
the computer as to avoid crimping it by the
expansion card cover (see page 1-4, Figure 3 for
illustration). Rotate the expansion card cover
into place over the PCI slots (Figure 11).
2. Replace the case cover onto your computer
(Figure 12).
3. Return the computer to your computing area
and reconnect the power and peripheral cables
to the computer.
Turn On Computer
1. Turn on your Power Macintosh.
2. For your computer to properly recognize a
new hard drive, you will need to initialize
it. Refer to Chapter 3, “Hard Drive Initializing”
for further instructions.
Figure 9
Figure 10
Figure 11
Figure 12
Ultra ATA66 cable
Tempo