SKC DatraTrac 2000 for the AirChek 2000_3000 - Manual (Page 13)

11
Real Time Monitor Display
The Real Time Monitor display (Figure 6) shows the operating
status of the connected AirChek 2000/3000 pump.
Monitor Display Cell Readout
Pump Status .........................FLOW: Pump in Run mode
HOLD: Pump in Hold mode
FAULT: Pump in Flow Fault mode
PROG (HOLD): Pump program in memory, pump in
Hold mode
Flow .......................................current fl ow rate in mL/min
Volume ..................................volume of air pumped
Run Time ..............................total run time of pump since reset
Total Time .............................total run time of pump since factory calibration
Batt ery icon ..........................graphically displays batt ery life. The batt ery life is in-
dicated by a light-colored bar with low (-) charge indi-
cated on the left side and full (+) charge indicated on the
right side. A batt ery with a full charge is displayed by
the length of this light-colored bar. A long light-colored
bar (closer to the + end) represents a batt ery near a full
charge. A short light-colored bar (closer to the - end)
represents a batt ery near depletion.
The data in the cells is updated every 5 seconds. If the operation of the pump is
changed, the cells will display the previous values for up to 5 seconds before they
are updated.
Figure 6. Real Time
Monitor Display
SKC Real Time Monitor Window