Setup – SKC 210-5000 AirChek XR5000 User Manual
Page 8
5
Power supply
jack
Charge status
LED
on SKC pump battery packs.
Reading the Charging Status LED on the Single Charger
The Li-Ion Charging Unit (Cat. No. P22300) indicates battery charge status via
an LED on the unit that blinks in specifi c patterns. Observe the LED steadily for
> 5 seconds to read charge status.
LED Action
Charge Status
ON
steady
Charge in progress
ON
2 sec
OFF
.25 sec
ON
2 sec
(Repeats)
Approximately
80% charged
OFF
2 sec
ON
.25 sec
OFF
2 sec
(Repeats)
Charge completed
The battery pack may be kept on SKC-approved Li-Ion battery chargers for
an indefi nite time.
Cautions:
• Do not charge or operate pump from charger in hazardous
locations.
• Use only the charger and battery packs designed for the AirChek
XR5000 pump to ensure reliable performance. Failure to do so will
void any warranty.
• For safe operation in hazardous locations, ensure the pump label
contains the
logo and the battery pack label contains Cat.
No. P85004 or P85002. Use of any other battery pack or device to
power the pump voids the UL Listing for intrinsic safety.
• Tampering with the battery pack or using a repaired or rebuilt
battery pack voids any warranty and UL Listing for intrinsic safety.
• Do not open, disassemble, short circuit, crush, incinerate, or
expose the battery to fi re or high temperatures.
• Use only the SKC-approved charger for this pump. Use of an
unapproved charger may damage the battery and pump and voids
any warranty.
• Failure to follow warnings and cautions voids any warranty.
Setup
Note