Battery replacement, Replacing the li-ion battery pack – SKC 210-5000 AirChek XR5000 User Manual
Page 19
16
Battery Replacement
Note
1
2
2
STOP!
SKC pump battery packs.
Replacing the Li-Ion Battery Pack
For models containing a lithium-ion battery pack only
To retain display data, ensure pump is placed in Hold before
disconnecting the battery pack. Display data will not be retained if
battery is removed while pump is running.
Removing Existing Battery Pack
1. Release the battery pack by removing the two screws on
the bottom of the battery pack housing.
2. Pull battery pack housing away from pump case.
Installing the New Battery Pack
Completely charge a new battery pack before operating the pump
(see page 4).
It may be necessary to charge the battery a few times before maximum battery
capacity is achieved.
1. Align the pump case with the battery pack. The etched SKC logo should be on
the same side as the LCD and keypad. Press the two parts together until snug. The
pump will power up and the LCD will display the last mode used (typically Hold)
and possibly accumulated run time from the last sample run.
2. Replace 2 screws on the bottom of the battery pack housing
and use a Phillips head screwdriver to tighten screws in an
alternating fashion.
3. Charge the new battery pack completely before use.
If the pump does not operate as expected after replacing the battery pack, see
Maintenance, Resetting Pump to Manufacturer Settings.
Note