SKC DCS (Deployable Cartridge Sampler) System - Manual (Page 10)

7
SAMPLE PUMP OPERATION
The user may choose to:
• Operate the pump manually in the fi eld (on/off )
• Program a schedule into the pump manually
• Program the pump for multiple schedules from a PC
with optional DataTrac ® for Leland Legacy Soft ware
(see Ordering Information, Accessories on page 14).
See page 9 for a Quick Guide to operate the SKC Leland
Legacy Sample Pump. For advanced programming, see the
complete Leland Legacy Pump Operating Instructions.
Charging the Battery
Completely charge a new batt ery pack using the SKC-approved charger (Cat. No.
223-241) before operating the pump. It may be necessary to charge the batt ery a
few times before maximum batt ery capacity is achieved.
Cautions:
• Do not charge or operate pump with or without charger in hazardous
locations.
• Use only the SKC-approved charger for this pump. Use of an
unapproved charger may damage the batt ery and pump.
• Use of a non-approved charger voids any warranty.
• Do not open, disassemble, short circuit, crush, incinerate, or expose the
batt ery to fi re or high temperatures.
• Tampering with the batt ery pack voids any warranty.
• Ensure proper orientation of charging cable before plugging it into the
charging jack. Improper orientation/contact will short-circuit the batt ery
and voids any warranty.
• Short-circuiting the batt ery pack will render it immediately inoperative.
• Failure to follow warnings and cautions voids any warranty.
The batt ery pack may be kept on the SKC-approved charger for an
indefi nite time.
1. Insert the plug from the charging unit into the
charging port on the batt ery adapter (on top of the
external batt ery assembly).
2. Insert plug from power supply into the jack on the
charging unit.
3. Install the appropriate wall plug on the power
supply and plug power supply into a wall outlet.
The batt ery will recharge in approximately 15
hours. For a complete charge, do not run the pump
connected to the external batt ery assembly during
charging. Aft er charging is complete, disconnect
1
External
battery
assembly
Battery
adapter
Charging
unit plug
Power
supply
Charging
unit
External
battery
assembly